Product · ECOVACS
Ecovacs N30 Pro Omni: edge mopping and 320 min runtime
Note: This page contains affiliate links. If you buy through them we may earn a commission at no extra cost to you. Learn more
The Deebot N30 Pro Omni is aimed at large homes that need a long run between charges and a robot that mops right up to the skirting boards. Ecovacs quotes a maximum runtime of 320 minutes from a 5,200 mAh battery, the longest figure among the mopping robots on this site. The other highlight is TruEdge, a hovering arm that pushes a mop pad into edges and corners with 1 mm accuracy.
- Mop type
- Dual OZMO Turbo spinning pads, TruEdge arm
- Water control
- Not stated
- Mop lift
- Yes, height not stated
- Mop drying
- 40°C hot air
- Suction
- 10,000 Pa
In its favour
- TruEdge adaptive edge mopping uses a hovering arm to work along walls and into corners.
- Hot-air drying at 40°C after cleaning keeps the pads from sitting damp in the station.
- Up to 320 minutes of runtime from a 5,200 mAh battery, the longest in this guide.
Good to know
- The model number ends in 'US' and the spec lists 110 V, so confirm UK plug and support before buying.
- Lift height and water-flow settings are not given, and the 320 minutes applies to quiet or vacuum-only mode.
Our take
Runtime in context
The 320 minute figure and the claimed 550 m² of coverage apply to silent or vacuum-only mode, as the listing makes clear. Mopping with full suction will use more power, so treat 320 minutes as a ceiling rather than an everyday number.
When the battery does run low, the robot works out how much to recharge and goes back to finish the job, which helps on large floors.
Mopping and edges
The dual OZMO Turbo 2.0 pads are driven by a 25,000 RPM motor, which Ecovacs says imitates hand movements. TruEdge uses a hovering arm and algorithms to reach edges and corners, with a claimed 99% gain in hard-to-reach coverage. The pads lift automatically, but the listing gives no lift height or water-flow levels, so rugs and delicate wood need care at first.
Suction, navigation and the station
Suction is listed at 10,000 Pa with ZeroTangle 2.0, which is designed to keep long human and pet hair off the main brush. TrueDetect 3D 3.0 handles obstacle avoidance, and TrueMapping 2.0 maps up to 100 m² in six minutes. The station empties the bin, washes the mops and dries them with 40°C air, and the baseplate detaches for cleaning. The spec table lists 110 V and 65 dB, so check you are getting the UK version.
How it compares
The Ecovacs T50 Max Pro Omni has nearly twice the suction and an 18 mm lift, at the cost of a shorter 200 minute runtime. The eufy X10 Pro Omni lifts its pads by a stated 12 mm and dries at 45°C, but runs for 180 minutes. The N30 Pro Omni wins on endurance and edge work.
Verdict
The N30 Pro Omni is a sensible pick for big, mostly hard-floored homes where one long run and clean edges matter more than peak suction. If you have many rugs, the Ecovacs T50 Max Pro Omni lifts its mop much higher. If carpet pickup is the priority, the Ecovacs T90 Pro Omni or Dreame L40 Ultra Gen2 offer far stronger suction.
Compared with alternatives in: Best robot mops for hardwood floors, Ecovacs Deebot models compared: X, T and N ranges
Amazon listing title: ECOVACS DEEBOT N30 Pro Omni Robot Vacuum and Mop, 2024 New Launch, 10000Pa Suction, TruEdge Adaptive Edge Mopping, ZeroTangle 2.0 Technology, Hot Air-Drying, Self-Emptying, Auto-Lift Mopping